What is the most likely cause of an "FDD controller Failure" error message?
A. you did not set the jumper on the floppy drive to drive A
B. you forgot to flash CMOS
C. you installed the floppy disk drive cable backward
D. your computer's floppy drive is defective
E. None of the above
Answer: Option C
This Question Belongs to Computer Science >> Computer Hardware
From what location are the 1st computer instructions available on boot up?
A. ROM BIOS
B. CPU
C. boot.ini
D. CONFIG.SYS
E. None of the above
What could cause a fixed disk error.
A. No-CD installed
B. bad ram
C. slow processor
D. Incorrect CMOS settings
E. None of the above
Missing slot covers on a computer can cause?
A. over heat
B. power surges
C. EMI.
D. incomplete path for ESD
E. None of the above
When installing PCI NICS you can check the IRQ availability by looking at
A. Dip switches
B. CONFIG.SYS
C. Jumper settings
D. Motherboard BIOS
E. None of the above
Join The Discussion