Which of the following is disadvantage in contact mode scaning
A. Higher possibility of tip damage
B. Slow scan speed
C. Can't be done for rough sample
D. Very poor resolution of scanning
Answer: Option A
This Question Belongs to Metallurgical Engineering >> Introduction To Metallurgy
Related Questions on Introduction to Metallurgy
Which of the following are not commercially manufactured by powder metallurgy
A. Aircraft brake pads
B. Self-lubricating bearings
C. Tungsten carbide based cutting tools
D. Turbine blades
A. 10 degrees
B. 21 degrees
C. 30 degrees
D. 50 degrees
Which crystal system does not have all axial angles at 90 degrees?
A. Tetragonal
B. rhombohedral
C. orthorhombic
D. cubic
Join The Discussion