Which of the following statement is wrong as regard to down milling?
A. It can not be used on old machines due to backlash between the feed screw of the table and the nut.
B. The chips are disposed off easily and do not interfere with the cutting.
C. The surface milled appears to be slightly wavy.
D. The coolant can be poured directly at the cutting zone where the cutting force is maximum.
Answer: Option C
The carbide tools operating at very low cutting speeds (below 30 m/min)
A. Reduces tool life
B. Increases tool life
C. Have no effect on tool life
D. Spoils the work piece
The type of reamer used for reaming operation in a blind hole, is
A. Straight fluted reamer
B. Left hand spiral fluted reamer
C. Right hand spiral fluted reamer
D. Any one of these
High speed steel tools retain their hardness up to a temperature of
A. 250°C
B. 350°C
C. 500°C
D. 900°C
Join The Discussion