Automobile Engine MCQ Questions & Answers

1

In a head lamp the metal shield is placed below the

A) Dipper beam B) Main beam C) Both the beams D) None of these

Discuss

Answer & Solution

Answer: Option A

No explanation is given for this question. Let's Discuss on Board

2

Aworm gear is used as the pinion for the rack and pinion type of steering gearbox, because it

A) Improves steering comfort when steering wheel is turned to effect small changes in the direction of forward motion B) Allows the steering wheel to be turned by a greater amount when steering C) Makes the steering more responsive D) Reduces the amount of kickback for large steering angles

Discuss

Answer & Solution

Answer: Option A

No explanation is given for this question. Let's Discuss on Board

3

Differential mechanism at the axle is provided mainly to

A) Enable the vehicle go round corners B) Equalize the division of torque between the two wheels C) To provide a reduction ratio D) To tum the drive through a right angle

Discuss

Answer & Solution

Answer: Option A

No explanation is given for this question. Let's Discuss on Board

4

The component of battery ignition system which helps to avoid spark between CB point is:

A) Ballast resistor B) Condenser C) Rotor D) Spark plug

Discuss

Answer & Solution

Answer: Option B

No explanation is given for this question. Let's Discuss on Board

5

Which of these were or are used in automobiles to provide suspension.

A) Leaf springs B) Coil springs C) Torsion bars D) All of the mentioned

Discuss

Answer & Solution

Answer: Option D

No explanation is given for this question. Let's Discuss on Board

6

A transistor consists of a base,

A) Diode and emitter B) Diode and collector C) Emitter and collector D) Diode and thyristor

Discuss

Answer & Solution

Answer: Option C

No explanation is given for this question. Let's Discuss on Board

7

Intake, compression, power, exhaust are the part of-

A) Cycle B) Throw C) Bore D) Stroke

Discuss

Answer & Solution

Answer: Option A

No explanation is given for this question. Let's Discuss on Board

8

Is it correct or not? A frame is that part of a car which supports the body, engine and power train.

A) Correct B) Incorrect C) Both D) None

Discuss

Answer & Solution

Answer: Option A

No explanation is given for this question. Let's Discuss on Board

9

The fluid coupling is most efficient as drive ratio approaching to

A) 1 : 1 B) 2 : 1 C) 1.5 : 1 D) 1 : 3

Discuss

Answer & Solution

Answer: Option A

No explanation is given for this question. Let's Discuss on Board

10

The centre part of a typical universal joint is called the

A) Trunnion B) Joint C) Bearing D) Spider

Discuss

Answer & Solution

Answer: Option D

No explanation is given for this question. Let's Discuss on Board

Automobile Engine MCQ Questions & Answers | Automobile Engineering