Heating And Welding MCQ Questions & Answers

1

Radiations from a black body are proportional to

A) T B) T² C) T³ D) T⁴

Discuss

Answer & Solution

Answer: Option D

No explanation is given for this question. Let's Discuss on Board

2

Properly of low temperature co-eflficient of heating element is desired due to which of the following reasons?

A) To avoid initial rush of current B) To avoid change in kW rating with temperature C) Both (A) and (B) D) Either (A) or (B)

Discuss

Answer & Solution

Answer: Option C

No explanation is given for this question. Let's Discuss on Board

3

The material of the heating element for a furnace should have

A) Lower melting point B) Higher temperature coefficient C) High specific resistance D) All of the above

Discuss

Answer & Solution

Answer: Option C

No explanation is given for this question. Let's Discuss on Board

4

In induction heating __________ is abnormally high.

A) Phase angle B) Frequency C) Current D) Voltage

Discuss

Answer & Solution

Answer: Option B

No explanation is given for this question. Let's Discuss on Board

5

For the transmission of heat from one body to another

A) Temperature of the two bodies must be different B) Both bodies must be solids C) Both bodies must be in contact D) At least one of the bodies must have some source of heating

Discuss

Answer & Solution

Answer: Option A

No explanation is given for this question. Let's Discuss on Board

6

When a body reflects entire radiation incident on it, then it is known as

A) White body B) Grey body C) Black body D) Transparent body

Discuss

Answer & Solution

Answer: Option A

No explanation is given for this question. Let's Discuss on Board

7

Heat transfer by condition will not occur when

A) Bodies are kept in vacuum B) Bodies are immersed in water C) Bodies are exposed to thermal radiations D) Temperatures of the two bodies are identical

Discuss

Answer & Solution

Answer: Option D

No explanation is given for this question. Let's Discuss on Board

8

A perfect black body is one that

A) Transmits all incident radiations B) Absorbs all incident radiations C) Reflects all incident radiations D) Absorbs, reflects and transmits all incident radiations

Discuss

Answer & Solution

Answer: Option B

No explanation is given for this question. Let's Discuss on Board

9

For heating element high resistivity material is chosen to

A) Reduce the length of heating element B) Increase the life of the heating element C) Reduce the effect of oxidation D) Produce large amount of heat

Discuss

Answer & Solution

Answer: Option A

No explanation is given for this question. Let's Discuss on Board

10

Which of the following heating methods has maximum power factor?

A) Arc heating B) Dielectric heating C) Induction heating D) Resistance heating

Discuss

Answer & Solution

Answer: Option D

No explanation is given for this question. Let's Discuss on Board

Heating And Welding MCQ Questions & Answers | Electrical Engineering