Measurement And Instrumentation MCQ Questions & Answers

Measurement And Instrumentation MCQ Questions & Answers | ECE

Learn Measurement And Instrumentation MCQ questions & answers are available for a Electronics and Communications Engineering(ECE) students to clear GATE exams, various technical interview, competitive examination, and another entrance exam. Measurement And Instrumentation MCQ question is the important chapter for a Electronics and Communications Engineering(ECE) and GATE students.

One single phase wattmeter operating on 230V and 5A for 5 hours makes 1940 revolutions. Meter constant in revolutions is 400. What is the power factor of the land?

A) 1 B) 0.84 C) 0.73 D) 0.65

Discuss

Answer & Solution

Answer: Option B

No explanation is given for this question. Let's Discuss on Board

The spring material used in a spring control device should have the following property.

A) Should be nonmagnetic B) Most be of low temperature coefficient C) Should have low specific resistance D) All of the above

Discuss

Answer & Solution

Answer: Option D

No explanation is given for this question. Let's Discuss on Board

Why is a MISC meter not recommended for DC measurement?

A) The meter is calibrated for AC and it’s error for DC would be high B) The meter does not respond to DC signals C) The error is high due to hysteresis effect D) The error is high due to eddy current effect

Discuss

Answer & Solution

Answer: Option C

No explanation is given for this question. Let's Discuss on Board

A moving iron ammeter may be compensated for frequency errors by

A) A shunt resistance B) A series inductance C) Shunt capacitance D) Series resistance

Discuss

Answer & Solution

Answer: Option C

No explanation is given for this question. Let's Discuss on Board

Which of the following meters has a linear scale?

A) Thermocouple meter B) Moving iron meter C) Hot wore meter D) Moving coil meter

Discuss

Answer & Solution

Answer: Option D

No explanation is given for this question. Let's Discuss on Board

For handling greater currents induction watt-meters are used in conjunction with

A) Potential transformers B) Current transformers C) Power transformers D) Either of the above

Discuss

Answer & Solution

Answer: Option B

No explanation is given for this question. Let's Discuss on Board

When using ohmmeter, applied voltage is to be disconnected from the circuit because

A) Voltage source will increase resistance B) Current will decrease resistance C) The ohmmeter has its own internal battery D) None of the above

Discuss

Answer & Solution

Answer: Option C

No explanation is given for this question. Let's Discuss on Board

A 10MHz CRO has

A) 5MHz sweep B) 10MHz vertical oscillator C) 10MHz horizontal oscillator D) 10MHz supply frequency

Discuss

Answer & Solution

Answer: Option C

No explanation is given for this question. Let's Discuss on Board

A CRO can display

A) AC signals B) DC signals C) Both AC and DC signals D) Time invariant signals

Discuss

Answer & Solution

Answer: Option C

No explanation is given for this question. Let's Discuss on Board

A galvanometer has

A) Air friction damping B) Fluid friction damping C) Spring coil damping D) Eddy current damping

Discuss

Answer & Solution

Answer: Option D

No explanation is given for this question. Let's Discuss on Board