Engineering Drawing MCQ Questions & Answers

1

Switches and relays should be shown in this position with no operating force or applied energy:

A) Normal B) Closed C) Offset D) Application

Discuss

Answer & Solution

Answer: Option A

No explanation is given for this question. Let's Discuss on Board

2

These types of pipes are generally connected with bell and spigot joints or flanged joints:

A) Soil and waste B) Water and gas C) Water and steam D) Gas and soil

Discuss

Answer & Solution

Answer: Option B

No explanation is given for this question. Let's Discuss on Board

3

An engineer's scale would be used to measure lines on a drawing where the scale factor reads ________.

A) $${\frac{1}{4}^{''}} = {1^{'}}{\text{ - }}{0^{''}}$$ B) $${\frac{1}{8}^{''}} = {1^{'}}{\text{ - }}{0^{''}}$$ C) $${1^{''}} = {100^{'}}$$ D) $${\frac{3}{4}^{''}} = {1^{'}}{\text{ - }}{0^{''}}$$

Discuss

Answer & Solution

Answer: Option C

No explanation is given for this question. Let's Discuss on Board

4

Using the Relative Polar Coordinate System to add a 3 inch line that is 45 degrees from the end point of the line created above the drafter would ________.

A) Type @3<45 and enter B) Type 3 back slash and enter C) Type 3 forward slash and enter D) Type 3 and try to use the Dynamic Input readout to find the end point

Discuss

Answer & Solution

Answer: Option A

No explanation is given for this question. Let's Discuss on Board

5

The ________ tool on the Dimension tool bar places the length of an arch on a drawing.

A) Arc Radius B) Arc Length C) Radius D) Diameter

Discuss

Answer & Solution

Answer: Option B

No explanation is given for this question. Let's Discuss on Board

6

These are special installations of stone or concrete marking the locations of points accurately determined by precise surveying:

A) Topographic marks B) Hatches C) Monuments D) Pillars

Discuss

Answer & Solution

Answer: Option C

No explanation is given for this question. Let's Discuss on Board

7

The Press-Pull tool will ________ the face of a solid model in the direction it faces.

A) Taper B) Extrude C) Spiral D) None of the above

Discuss

Answer & Solution

Answer: Option B

No explanation is given for this question. Let's Discuss on Board

8

In this type of view, the cutting plane line indicates both the location of the cutting plane and the direction of sight:

A) Removed section B) Revolved section C) Auxiliary section D) Partial section

Discuss

Answer & Solution

Answer: Option C

No explanation is given for this question. Let's Discuss on Board

9

When designing a home for a client, one of the most important pre-design considerations that an architect needs to address is ________.

A) How much money the client is willing to spend B) The site on which the house is to sit C) The nearest grocery store D) Whether or not there is a curb and gutter system

Discuss

Answer & Solution

Answer: Option B

No explanation is given for this question. Let's Discuss on Board

10

This is formed where three or more surfaces intersect:

A) Oblique B) Line C) Edge D) Vertex

Discuss

Answer & Solution

Answer: Option D

No explanation is given for this question. Let's Discuss on Board

Engineering Drawing MCQ Questions & Answers | Mechanical Engineering