A. Decreasing the lever arm
B. Increasing the total perimeter of bars
C. Replacing larger bars by greater number of small bars
D. Replacing smaller bars by greater number of greater bars
Answer: Option C
This Question Belongs to Civil Engineering >> RCC Structures Design
Distribution of shear intensity over a rectangular section of a beam, follows:
A. A circular curve
B. A straight line
C. A parabolic curve
D. An elliptical curve
If the shear stress in a R.C.C. beam is
A. Equal or less than 5 kg/cm2, no shear reinforcement is provided
B. Greater than 4 kg/cm2, but less than 20 kg/cm2, shear reinforcement is provided
C. Greater than 20 kg/cm2, the size of the section is changed
D. All the above
In a pre-stressed member it is advisable to use
A. Low strength concrete only
B. High strength concrete only
C. Low strength concrete but high tensile steel
D. High strength concrete and high tensile steel
In a simply supported slab, alternate bars are curtailed at
A. $${\frac{1}{4}^{{\text{th}}}}$$ of the span
B. $${\frac{1}{5}^{{\text{th}}}}$$ of the span
C. $${\frac{1}{6}^{{\text{th}}}}$$ of the span
D. $${\frac{1}{7}^{{\text{th}}}}$$ of the span
Actually there is a typing error here.
The bond stress can be reduced by replacing larger dia bars by greater number of smaller dia bars.
Limiting value of bond stress is 1MPa.
Not load stress...it should be bond stress