Diameter of a bolt hole is usually taken as
A. Gross diameter of bolt
B. Nominal diameter +1.5 mm
C. Nominal diameter +2.0 mm
D. Nominal diameter of bolt
Answer: Option B
This Question Belongs to Civil Engineering >> Design Of Steel Structures
Join The Discussion
Comments ( 5 )
Related Questions on Design of Steel Structures
Rivets connecting flange angles to cover plates in a plate girder are subjected to
A. Horizontal shear only
B. Vertical load only
C. Both (A) and (B)
D. None of the above
When the axis of load lies in the plane of rivet group, then the rivets are subjected to
A. Only shear stresses
B. Only tensile stresses
C. Both (A) and (B)
D. None of the above
Hudson’s formula gives the dead weight of a truss bridge as a function of
A. Bottom chord area
B. Top chord area
C. Effective span of bridge
D. Heaviest axle load of engine
How??it should be nominal + 2mm
C is correct
Answer should be( A) that hole is called as gross dia of bolt
C is correct and b is correct for rivet
C is the right answer for bolt.
B is for rivet.