In an open loop control system
A. Output is independent of control input
B. Output is dependent on control input
C. Only system parameters have effect on the control output
D. None of the above
Answer: Option A
Solution(By Examveda Team)
An open-loop system is defined by the fact that the output signal or condition is neither measured nor fed back for comparison with the input signal or system set point. Therefore open-loop systems are commonly referred to as “Non-feedback systems”.This Question Belongs to Electrical Engineering >> Electrical Control Systems
Join The Discussion
Comments ( 1 )
Related Questions on Electrical Control Systems
The position and velocity errors of a type-2 system are
A. constant, constant
B. constant, infinity
C. zero, constant
D. zero, zero
A. system stability
B. system gain
C. system stability and gain
D. none of the above
A. Auto-pilot for an aircraft
B. Direct current generator
C. Car starter
D. Electric switch
The effect of error damping is to
A. provide larger settling lime
B. delay the response
C. reduce steady state error
D. any of the above
E. none of the above
wrong answer
in an open loop system
output depends on inputs
but inputs does not depend on output