Process Equipment And Plant Design MCQ Questions & Answers

Process Equipment And Plant Design MCQ Questions & Answers | Chemical Engineering

Learn Process Equipment And Plant Design MCQ questions & answers are available for a Chemical Engineering students to clear GATE exams, various technical interview, competitive examination, and another entrance exam. Process Equipment And Plant Design MCQ question is the important chapter for a Chemical Engineering and GATE students. Page-9 section-4

$$\frac{{{{\text{L}}_{\text{e}}}}}{{\text{D}}}$$ for 90° elbow (medium radius) and 90° square elbow would be respectively around

A) 25 and 60 B) 3 and 5 C) 100 and 250 D) 250 and 600

Discuss

Answer & Solution

Answer: Option A

No explanation is given for this question. Let's Discuss on Board

In a __________ rivetted joint, the rivets in the various rows are opposite to each other.

A) Zig-zag B) Chain C) Diamond D) None of these

Discuss

Answer & Solution

Answer: Option B

No explanation is given for this question. Let's Discuss on Board

The units of Young's modulus of elasticity and __________ are the same.

A) Strain B) Stress C) Modular ratio D) None of these

Discuss

Answer & Solution

Answer: Option B

No explanation is given for this question. Let's Discuss on Board

Height equivalent to a theoretical plate (HETP) is the height of packing that will give the same separation as one theoretical plate in gas-liquid mass transfer operations like distillation, absorption/stripping and humidification/dehumidification. HETP which is experimentally determined, depends upon the

A) Flow rates of each fluid B) Type and size of packing C) Concentration of each fluid D) All of the above

Discuss

Answer & Solution

Answer: Option D

No explanation is given for this question. Let's Discuss on Board

Tube height in a calendria type evaporator is normally less than __________ metres.

A) 1 B) 2 C) 3.5 D) 5.5

Discuss

Answer & Solution

Answer: Option B

No explanation is given for this question. Let's Discuss on Board