51. The factor considered for evaluation of machinability is
52. When the temperature of a solid metal increases,
53. In lapping operation, the amount of metal removed is
54. In metal machining, the zone where the maximum heat is generated due to the plastic deformation of metal, is called
55. Which of the following operations can be performed with milling cutters?
56. Volume of a cube of side ‘$$l$$’ and volume of a sphere of radius ‘r’ are equal. Both the cube and the sphere are solid and of same material. They are being cast. The ratio of the solidification time of the cube to the same of the sphere is
57. The maximum production of small and slender parts is done by
58. The method of centre less grinding used to produce taper is
59. In a milling operation, two side milling cutters are mounted with a desired distance between them so that both sides of a workpiece can be milled simultaneously. This set up is called
60. A tool used to withdraw a drill from the sleeve is called
Read More Section(Manufacturing and Production Technology)
Each Section contains maximum 100 MCQs question on Manufacturing and Production Technology. To get more questions visit other sections.