Process Equipment And Plant Design MCQ Questions & Answers

Process Equipment And Plant Design MCQ Questions & Answers | Chemical Engineering

Learn Process Equipment And Plant Design MCQ questions & answers are available for a Chemical Engineering students to clear GATE exams, various technical interview, competitive examination, and another entrance exam. Process Equipment And Plant Design MCQ question is the important chapter for a Chemical Engineering and GATE students. Page-9 section-2

Power required for agitation depends upon the

A) Height & properties of the liquid B) Agitator type & speed of agitation C) Size of agitator & the tank D) All of the above

Discuss

Answer & Solution

Answer: Option D

No explanation is given for this question. Let's Discuss on Board

Which of the following types of reactors is the safest from operation point of view?

A) A vapor phase reactor B) Pot type reactor C) A liquid phase reactor D) A liquid phase catalytic reactor

Discuss

Answer & Solution

Answer: Option A

No explanation is given for this question. Let's Discuss on Board

A/an __________ is used for changing the direction of a pipeline.

A) Elbow B) Union C) Flange D) Disc compensator

Discuss

Answer & Solution

Answer: Option A

No explanation is given for this question. Let's Discuss on Board

Pressure differential maintained across a continuous rotary vacuum filter is in the range of __________ mm Hg column.

A) 50 to 100 B) 100 to 150 C) 250 to 500 D) 600 to 700

Discuss

Answer & Solution

Answer: Option C

No explanation is given for this question. Let's Discuss on Board

The necessary wall thickness for a metallic storage vessel is a function of the

A) Ultimate tensile strength (or yield point) of the material and operating temperature B) Operating pressure and welding/joint efficiency C) Diameter of the vessel D) All of the above

Discuss

Answer & Solution

Answer: Option D

No explanation is given for this question. Let's Discuss on Board

Pick out the wrong statement pertaining to the design of the distillation column.

A) Generally, a skirt clerance of 0.5" to 1.5' is recommended to prevent plugging of the slots by residue build up B) The purpose of the slot is to disperse the gas into the liquid in the form of small bubbles C) If sufficient slot area is not provided, the gas may pass through the skirt clearance D) None of these

Discuss

Answer & Solution

Answer: Option D

No explanation is given for this question. Let's Discuss on Board

The safe height (h) to diameter (d) ratio (i.e., h/d) for liquid/petro fuel storage tank of capacity more than 45 kilolitres is less than

A) 1 B) 2 C) 3 D) 3.5

Discuss

Answer & Solution

Answer: Option A

No explanation is given for this question. Let's Discuss on Board

At equal mass velocities, the values of film co-efficients for gases as compared to that for liquids are generally.

A) Higher B) Lower C) Same D) Unpredictable

Discuss

Answer & Solution

Answer: Option B

No explanation is given for this question. Let's Discuss on Board

Frame thickness in the plate and frame filter press is normally in the range of __________ inches.

A) 0.25 to 4 B) 0.25 to 8 C) 1 to 5 D) 1 to 12

Discuss

Answer & Solution

Answer: Option B

No explanation is given for this question. Let's Discuss on Board

Rotary driers are most economically designed for the number of heat transfer units (HTU) from

A) 0.01 to 1 B) 1.5 to 2.5 C) 5 to 10 D) 10 to 20

Discuss

Answer & Solution

Answer: Option B

No explanation is given for this question. Let's Discuss on Board