Manufacturing And Production Technology MCQ Questions & Answers

Learn Manufacturing And Production Technology MCQ questions & answers are available for a Mechanical Engineering students to clear GATE exams, various technical interview, competitive examination, and another entrance exam. Manufacturing And Production Technology MCQ question is the important chapter for a Mechanical Engineering and GATE students. Page-10 section-3

Each section contains 100 MCQs on Manufacturing and Production Technology .

The abrasive recommended for grinding materials of high tensile strength is

A) Silicon carbide B) Aluminium oxide C) Sand stone D) Diamond

Discuss

Answer & Solution

Answer: Option B

No explanation is given for this question. Let's Discuss on Board

The abrasive recommended for grinding materials of low tensile strength is

A) Silicon carbide B) Aluminium oxide C) Sand stone D) Diamond

Discuss

Answer & Solution

Answer: Option A

No explanation is given for this question. Let's Discuss on Board

The cutting force in up milling ________ per tooth movement of the cutter.

A) Is zero B) Is maximum C) Decreases from maximum to zero D) Increases from zero to maximum

Discuss

Answer & Solution

Answer: Option D

No explanation is given for this question. Let's Discuss on Board

The factor responsible for the formation of discontinuous chips is

A) Low cutting speed and large rake angle B) Low cutting speed and small rake angle C) High cutting speed and large rake angle D) High cutting speed and small rake angle

Discuss

Answer & Solution

Answer: Option B

No explanation is given for this question. Let's Discuss on Board

The main purpose of a boring operation, as compared to drilling, is to

A) Drill a hole B) Finish the drilled hole C) Correct the hole D) Enlarge the existing hole

Discuss

Answer & Solution

Answer: Option D

No explanation is given for this question. Let's Discuss on Board

In a center lathe, the cutting tool is fed in _________ with reference to the lathe axis.

A) Cross direction only B) Longitudinal direction only C) Both cross and longitudinal direction D) Any direction

Discuss

Answer & Solution

Answer: Option C

No explanation is given for this question. Let's Discuss on Board

When the metal is removed by erosion caused by rapidly recurring spark discharges between the tool and work, the process is known as

A) Electrochemical machining B) Electro-discharge machining C) Ultrasonic machining D) None of these

Discuss

Answer & Solution

Answer: Option B

No explanation is given for this question. Let's Discuss on Board

The operation in which oil is permeated into the pores of a powder metallurgy product is known as

A) Mixing B) Sintering C) Impregnation D) Infiltration

Discuss

Answer & Solution

Answer: Option C

No explanation is given for this question. Let's Discuss on Board

The strength of a brazed joint

A) Decreases with increase in gap between the two joining surfaces B) Increases with increase in gap between the two joining surfaces C) Decreases up to certain gap between the two joining surfaces beyond which it increases D) Increases up to certain gap between the two joining surfaces beyond which it decreases

Discuss

Answer & Solution

Answer: Option D

No explanation is given for this question. Let's Discuss on Board

100

The rake angle of a single point cutting tool corresponds to _________ of a twist drill.

A) Lip clearance angle B) Helix angle C) Point angle D) Chisel edge angle

Discuss

Answer & Solution

Answer: Option B

No explanation is given for this question. Let's Discuss on Board

1 2 3 4 5 6 7 8 9 10

Manufacturing And Production Technology MCQ Questions & Answers | Mechanical Engineering