ExamVeda
Login
Home

Process Equipment And Plant Design MCQ Questions & Answers | Chemical Engineering

Learn Process Equipment And Plant Design MCQ questions & answers are available for a Chemical Engineering students to clear GATE exams, various technical interview, competitive examination, and another entrance exam. Process Equipment And Plant Design MCQ question is the important chapter for a Chemical Engineering and GATE students. Page-2 section-3

Each section contains 100 MCQs on Process Equipment and Plant Design .
11
The dust collection efficiency of electrostatic precipitator increases with increase in the
Discuss
Answer & Solution
Answer: Option B
No explanation is given for this question. Let's Discuss on Board
12
If 'D' is the inside diameter of the shell of a shell and tube heat exchanger, then the baffle spacing is usually in the range of
Discuss
Answer & Solution
Answer: Option B
No explanation is given for this question. Let's Discuss on Board
13
The minimum baffle height should be
Discuss
Answer & Solution
Answer: Option B
No explanation is given for this question. Let's Discuss on Board
14
Movement of pipeline caused by thermal expansion is taken care by providing
Discuss
Answer & Solution
Answer: Option D
No explanation is given for this question. Let's Discuss on Board
15
What is the slope of the operating line in the stripping section of a distillation column?
Discuss
Answer & Solution
Answer: Option C
No explanation is given for this question. Let's Discuss on Board
16
Correct use of 'factor of safety' is very important in equipment design. It is defined as the ratio of the
Discuss
Answer & Solution
Answer: Option B
No explanation is given for this question. Let's Discuss on Board
17
The minimum plate spacing in most of the pertroleum refinery distillation columns (of dia > 3 ft) is normally __________ inches.
Discuss
Answer & Solution
Answer: Option C
No explanation is given for this question. Let's Discuss on Board
18
The minimum tray spacing in distillation column of diameter less than 3 ft is normally __________ inches.
Discuss
Answer & Solution
Answer: Option A
No explanation is given for this question. Let's Discuss on Board
19
A head comprises of straight flange section, corner torus, section and central dished section. Crown radius and knuckle radius in a head is related respectively to the
Discuss
Answer & Solution
Answer: Option A
No explanation is given for this question. Let's Discuss on Board
20
The clearance between two tubes in a shell and tube heat exchanger is known as 'ligament', whose minimum value is __________ the outside diameter of the tube, but in no case it should be less than 4.5 mm.
Discuss
Answer & Solution
Answer: Option C
No explanation is given for this question. Let's Discuss on Board